HHO, Hydrogen, and Alt Energy News

How Long Does Electrolyte Activator Last in My HHO Kit?

From time to time, we get customers and people interested in purchasing one of our hydrogen kits, wanting to know how much electrolyte is consumed or used in their kits. 

There is no solid answer to this, as it varies by how much driving you do and how hard you run your hho kit, but there are some general usages I can tell you about.

First, let me clarify that you do NOT need to add more electrolyte/activator every time you add water. Remember that we are not creating hydrogen and oxygen out of thin air! We are breaking the water into its base molecules of hydrogen and oxygen (though it is a very small consumption rate of approximately 1800:1), so you will have to add some water to the reservoir on a regular basis: how much depends on various factors. 

An average hho generator running at 18 -20 amps will consume less water than one running at 25-28 amps. Our new series 880 generators use far less water than our older 77 series. When we were running and testing the prototypes, we found at 18 amps, we used only about 2 cups (Half a liter) of water for a whole month! At 25-30 amps we doubled the consumption which is still far less than others on the market today.

You will be able to get a good read on consumption after setting up and breaking in your hho kit after the first couple of weeks. We recommend checking it every time you fill up your gas, until you see what rate you are using. 

You ONLY have to top off with fresh distilled water, NOT water+ electrolyte! The electrolyte is a catalyst, not a consumable, so you will see your amp gauge slowly climbing as water is consumed. When you add more water- it will return to normal levels. Now, although technically the electrolyte is not a consumable. there is a very small trace amount that mixes with the hho gas (you can smell it in the unfiltered gas), so slowly, over time, you will see the amps start to drop as you keep refilling the reservoir. This is also why you MUST properly filter the gas before it enters the engine, or you WILL get white salts forming on your throttle plate and aluminum parts. Bubbler water must be changed frequently as well. Our new dry filters removes this very effectively.

When you see the Amps drop below your desired running amount, then it is time to add a spoonful mixed in with your next top off of water. Usually one spoon is all you need to bring it right back up.

Rule of Thumb: 

  1. Check every fill-up with fuel first few weeks, to see how often you need water in your hho kit
  2. Simply Top Off the reservoir with fresh Distilled water ONLY
  3. Monitor your amps as driving - when they get too low, time to add a spoon of electrolyte/activator
  4. Once a year, drain/clean and flush your hho system for optimum performance.

Hope that helps!

Bob

P.S. You can buy more electrolyte from our store, as well as the perfect Hydro Gen Cleaner. And if you do Not have a drain kit, get one to make life easier for you! Get any of those by clicking on these links if you need:

Electrolyte Activator: http://www.hhokitsdirect.com/collections/all/products/hho-generator-hydro-activator-electrolyte-16-ounces-454-grams

Hydro Gen Cleaner Power Pack: http://www.hhokitsdirect.com/collections/all/products/power-pack-cleaner-activator-for-hho-generators

Drain Kit: http://www.hhokitsdirect.com/collections/all/products/quick-connect-drain-kit-for-hho-kits